
If you’re taking photos of lightning, set a camera on a sturdy tripod, switch to manual focus on a distant light or the horizon, and shoot in Manual: at night start around ISO 100–200, f/5.6–8, and 6–15 seconds, firing continuously with an intervalometer so you don’t miss strikes; in brighter night scenes (city or moonlight) shorten to about 4–8 seconds and stop down if close bolts clip; in daylight use ISO 100, f/8–16, and a fast shutter around 1/125–1/500 with a lightning trigger or high‑speed bursts; on a phone, use Long Exposure/Live Photo or 4K/60 video and extract frames. Stay in a sheltered location like a vehicle, position near the storm’s edge, and adjust aperture narrower if close bolts blow out or wider if they’re distant.
Here’s the fast plan: mount the camera, aim where most bolts are firing, lock focus manually, and run continuous shots with minimal gaps. Use a remote or intervalometer to avoid shake and to keep a steady cadence. For daytime, either add a lightning trigger that fires the shutter the instant it detects a flash or run short bursts at a fast shutter; for phones, stabilize on a support, enable Live Photo/Long Exposure if available, or record 4K/60 and pull a crisp frame later. Always prioritize safety by shooting from shelter, tracking the storm’s motion with radar, and keeping distance; if nearby bolts overexpose, stop down one or two stops; if bolts look faint, open up or increase ISO slightly.
Taking photos of lightning: the 60‑second setup (fast answer)
Use these ready‑to‑apply starting points as your on‑site checklist. They are intentionally simple so you can lock them in quickly, then fine‑tune by a stop or two based on distance and ambient light.
- Night, dark sky: ISO 100–200, f/5.6–8, 8–12 s. Manual focus on a distant light. Intervalometer running continuously. Review for blown highlights and reduce exposure time or stop down if needed.
- Night, city/moonlight: ISO 100, f/8–11, 4–8 s. Stop down if close bolts clip. Shorter exposures reduce skyglow and increase frame count.
- Day: ISO 100, f/8–16, 1/125–1/500 with a lightning trigger or continuous bursts. Alternatively record 4K/60 video and pull frames. Aim for a clean horizon and keep the lens hooded to resist raindrops.
- Phone quick start: tripod or solid support; enable Live Photo/Long Exposure (iPhone) or similar modes; if not available, record video (4K/60) or bursts; lock focus/exposure if the app allows; stay sheltered.
Use the table below to compare scenarios and adjust on the fly.
| Scenario | ISO | Aperture | Shutter | Focus method | Capture method | Notes |
|---|---|---|---|---|---|---|
| Night, dark sky | 100–200 | f/5.6–8 | 6–15 s | Manual on distant light/horizon | Intervalometer continuous | Increase time for fewer bolts; shorten if sky brightens |
| Night, city or moonlight | 100 | f/8–11 | 4–8 s | Manual on distant light/horizon | Intervalometer continuous | Stop down if close bolts clip; shorter exposures reduce skyglow |
| Daylight with trigger | 100 | f/8–16 | 1/125–1/500 | Manual at infinity (fine tune) | Lightning trigger | Use narrower apertures for bright mid‑day scenes |
| Daylight without trigger | 100 | f/8–11 | 1/250–1/500 | Manual at infinity | High‑speed bursts or 4K/60 video | Keep buffer clear to sustain bursts |
| Smartphone (iOS/Android) | Auto (lowest) | Auto (lock if possible) | Live/Long Exposure or video | AF lock on distant point | Live Photo/Long Exposure or 4K/60 video | Stabilize; avoid digital zoom; crop later |
Essential gear and why it matters
Camera and lenses: A mirrorless or DSLR with Manual mode and RAW capture is ideal. A wide‑to‑standard zoom (e.g., 16–35, 24–70) gives context for bolts and foregrounds; a short telephoto (e.g., 70–200) helps isolate distant strikes when the storm is far away. Use a lens hood to reduce flare from rain and city lights. If your camera has weather sealing and a dedicated shutter port, that’s a plus, but you can work around it with simple rain covers and a remote.
Tripod and remote/intervalometer: Stability is non‑negotiable for night exposures. A solid tripod with a ball head lets you aim quickly. A cable release or intervalometer keeps frames rolling with minimal gaps, which is crucial because strikes are unpredictable. A basic wired intervalometer is inexpensive and simple; many cameras also offer built‑in interval timers. Either way, the goal is to keep your camera shooting continuously with the shortest gap your camera allows.
Lightning triggers: These small sensors detect the initial flash and fire the shutter, which is especially helpful in daylight when long exposures can’t capture strikes reliably. Consider the camera’s shutter lag and your trigger’s sensitivity; lower lag and higher sensitivity typically improve capture chances. Triggers add complexity and cost, but they’re valuable for daytime sessions and for photographers who want a higher capture rate without filling the buffer with bursts.
Weather protection and small extras: A rain cover or a simple clear plastic bag with a rubber band can keep gear dry, while a microfiber cloth helps wipe droplets from the front element. Silica gel packets in your bag can help with moisture, especially moving from AC to humid air. Pack spare batteries and memory cards because continuous shooting drains power and fills storage faster than normal.
- Field checklist
- Weather/radar app preloaded and open
- Safe, sheltered shooting spot (vehicle, covered structure)
- Tripod and lens hood
- Camera and wide/standard lens (telephoto optional)
- Intervalometer or remote release
- Lightning trigger (optional, helpful in daylight)
- Spare batteries and high‑speed memory cards
- Rain cover or plastic bag, rubber bands
- Microfiber cloth and small towel
- Silica gel packets to manage moisture
- Test shot step: check focus at 100% and check highlight warnings (“blinkies”) before continuous shooting
For deeper background on composing striking frames, see our guide on composition. If you’re new to long exposures, this companion field guide is a useful refresher: Master long exposure photography. And if you like working from repeatable processes, this article lays out a repeatable workflow you can adapt to storms: photography methodology tips.
Settings that work (night vs. day)
Night: Work in Manual mode. Start at ISO 100–200, f/5.6–8, and 6–15 seconds. If bolts are near and bright, stop down to f/8–11 and shorten to 4–8 seconds to protect highlights. If bolts are distant or the sky is very dark, open up to f/4–5.6 or raise ISO to 200–400 to keep a usable exposure length. Shooting RAW gives the latitude to recover highlights and adjust white balance later.
Day: Keep ISO at 100, set f/8–16 depending on brightness, and choose a fast shutter around 1/125–1/500. A lightning trigger or continuous high‑speed burst increases your odds of catching the exact instant. Video is a reliable alternative: record 4K/60 (or faster if available), then pull a frame in post. Avoid ND filters for daytime lightning unless you specifically want creative cloud blur; slowing the shutter risks missing the precise, very short flash of a bolt.
Focus: Disable autofocus to avoid hunting. Use Live View and magnify on a distant light or horizon edge, then set to manual. If visibility is poor, pre‑focus during twilight or on a bright distant subject, then tape the focus ring to prevent movement. Recheck after any bump or focal length change, and occasionally take a test shot and zoom in to ensure stars and distant lights are sharp.
Other tweaks: Set a fixed white balance (Daylight is a good baseline) for consistent color. Turn off long‑exposure noise reduction to avoid multi‑second gaps between frames; continuous cadence matters more than per‑frame NR for lightning. Enable highlight warnings and the histogram so clipped cores are obvious. If your camera offers Electronic Front Curtain Shutter or full electronic shutter, consider enabling it to reduce vibration (mind rolling‑shutter artifacts in lightning only if you also use video).
Positioning, planning, and basic safety
Planning tools matter. Use a weather app with radar and lightning maps to see where the storm core is moving and where strikes are happening. Position near the storm’s edge, ideally with clear air between you and the rain core to minimize raindrops on the lens and give cleaner visibility. A location with a wide view and a simple horizon helps highlight branching bolts.
Estimate distance with a simple rule: count seconds between the flash and thunder, then divide by 5 to estimate miles. For example, 10 seconds divided by 5 equals about 2 miles. More distance means more time to react and a safer shooting scenario. Photograph from shelter: a vehicle with the windows cracked for ventilation is a common, practical option. Buildings with covered areas also work. Avoid open fields, ridgelines, and isolated tall objects.
Choose compositions that keep you away from hazards. Add foreground interest like distant buildings, trees on a far ridge, or a shoreline, but stay clear of conductive structures. Know when to leave: if the rain core shifts toward you, or strikes begin hitting within a mile or two (two or three seconds between flash and thunder), pack up. No photo is worth a risky position.
A field workflow that catches more strikes
Compose first, then lock focus and exposure. Fire a short test sequence and review: zoom in to confirm sharpness on distant lights and check that bolt cores aren’t clipped. If highlights are blown, stop down a stop or shorten exposure; if bolts look faint, open up or increase ISO modestly. With confidence in focus and exposure, start continuous shooting.
Keep your intervalometer cadence tight. At night, 4–8 second exposures often balance sky brightness and volume of frames; shorter frames produce more chances to intersect a strike, which matters when activity is frequent. In darker rural skies, 8–12 seconds can work, but monitor highlight warnings and shorten as needed. If the storm is highly active, you may prefer a 4–6 second rhythm to maximize frame count.
Manage buffers and cards. Use fast cards and consider switching to compressed RAW or even RAW+JPEG if your camera struggles to write continuously. If your camera chokes, reduce exposure time slightly to decrease per‑frame data. Review only when a lull hits; avoid extended chimping that creates gaps. Protect winning frames by tagging or locking them during brief pauses so they aren’t accidentally deleted later.
Moisture control: Hood the lens to shed droplets, wipe with a microfiber cloth as needed, and watch for fogging from humidity. If fogging begins, step back to the car, warm the lens slightly with the defroster, and return when the glass clears. Keep a small towel to dry hands and gear. These quiet, routine steps prevent countless soft or hazy frames.
Phones: reliable ways to capture lightning
Handheld phones can succeed with a little stabilization and planning. If your phone offers Live Photo with Long Exposure (iPhone) or a similar mode on Android, place the phone on a tripod or firm surface, point toward the storm’s hot zone, and capture several Live frames; convert your favorite to Long Exposure in the Photos app, which blends motion to reveal the bolt path. If your phone doesn’t have that mode, record 4K/60 video or 1080/120–240 and scrub for the sharpest frame later.
Lock exposure and focus if the app allows, aiming at a distant point. Avoid digital zoom; instead, frame wider and crop later for sharper results. Keep the lens dry and clean to avoid flare and fogging, and brace the phone against a stable surface to avoid shake. When lightning is frequent, start and stop shorter video clips to keep files manageable and to make frame extraction easier later.
For composition and timing, treat the phone like a small camera: watch the storm’s rhythm, notice where bolts repeat, and keep the horizon level. If you want more manual control, third‑party camera apps can offer manual ISO, shutter, and focus locks; just remember that stability and a clear line of sight matter more than granular tweaks.
Post‑processing and stacking (fast, practical)
Start in RAW when possible. Set white balance to taste (Daylight often gives natural sky tones), pull down Highlights and Whites to control bolt cores, and use a touch of Clarity or Dehaze for structure. Lift Shadows carefully if you want more landscape detail, but protect the bolt’s edge contrast. Apply moderate noise reduction; lightning frames often tolerate a bit of texture to keep the bolt crisp.
To combine multiple bolts, stack frames shot from a locked tripod. In software that supports layers, align the frames (if needed) and use a Lighten blend mode to merge visible bolts from different exposures. Mask out duplicate rain streaks, ghosts, and any headlight trails you don’t want. Keep the composite believable by limiting the stack to a few adjacent frames with similar sky brightness.
Common issues and quick fixes:
- Blown bolt cores: reduce Highlights/Whites; if necessary, use a local adjustment to pull down the core while preserving the halo.
- Soft focus: discard and refocus on a distant light; tape the ring and recheck after any bump.
- Color cast: set WB to Daylight or adjust Tint and Temp toward neutral sky; city glow may require a slight magenta shift.
- Rain streaks: spot‑remove or mask in a cleaner sky from a neighboring frame taken within seconds.
FAQs: quick answers
How do I take a photo of lightning at night? Start around ISO 100–200, f/5.6–8, and 6–15 seconds on a tripod with manual focus and an intervalometer running continuously. Shorten exposures and stop down if the sky brightens or bolts clip.
Can I photograph lightning in daylight without a trigger? Yes. Set ISO 100, f/8–11, and 1/250–1/500. Use continuous high‑speed bursts and keep the buffer clear, or record 4K/60 video and extract the best frame.
How do I take lightning photos with an iPhone or Android? Stabilize the phone, use Live Photo/Long Exposure or similar modes, or record 4K/60 and pull frames. Lock focus/exposure if the app allows and avoid digital zoom.
What is the 5‑second rule for lightning distance? Count seconds between flash and thunder and divide by 5 to estimate miles. Fewer seconds means closer strikes and a greater need to retreat to shelter.
Do I really need a lightning trigger, and when is it worth it? A trigger helps most in daylight when fast shutters are required. At night, long exposures plus an intervalometer usually suffice. If you plan many daytime sessions or want higher capture odds without constant bursts, a trigger can be a good upgrade.
How do lightning photographers know when and where to shoot? They watch radar and lightning maps, position near the storm’s edge with clear sightlines, and keep distance from the core. Planning and safe positioning boost both hit rate and image quality.
With a grounded setup, a simple cadence, and a safety‑first plan, you’ll bring home more clean, dramatic lightning frames—and you’ll enjoy the process rather than fighting the storm.